JENCO 3671N pH, ORP In-line Controller

3671N

Description

1/8 DIN panel mount pH/ORP controller with dual SPDT Hi/Lo relays, manual set points and calibration are via potentiometers. Features a voltage/recorder output and an internal pH/ORP select switch. Display is a large bright red LED. Connectors are a BNC input and spade lug screw type connector block. Meter requires a Pt-100 ATC or a simulation resistor for temperature. Power115/230A AC.

• All solid state design
• Low cost
• Easy to install
• Set points on front panel
• Recorder output
• 0.56 high efficiency red led display
• 1/8 DIN aluminum case
• Set points cover entire span
• ATC for pH 0 to 100 °C
• Internal pH/ORP select switch
• Low power consumption design, reduced internal heating thus increased reliability

Specifications

• 	RANGE	RESOLUTION	ACCURACY
  pH	0 to 14.0	0.1	0.1 ± 1digit
  ORP	-1990 to 1990 mV	10	± 0.1% ± 1 digit
  Temp.	0 to 100 °C	1	1 ± 1 digit

• General

  • Input impedance: Greater than 10^12 ohm
  • Temp. compensation: Auto 0 to 100 °C
  • Recorder output (ph): 1400mV
  • Recorder output (mV): -1990 to 1990mV
  • Recorder output (temp.): 1000mV
  • Dual point on/off control: pH or orp with internal select switch
  • Dead band: ±0.1 pH for each set point
  • Relay output: 8a at 115VAC,4a at 230VAC
  • Readout: 0.56 high efficiency red LED display
  • Power source: 115 VAC/230VAC ¡à 15%,50/60hz
  • Dimension: 96mm x48mm x 172mm
  • Weight: 0.69 kg

Share this product